How to Calibrate a Spreader

Watch Video
Milorganite. For Better Results. Naturally.

Quick Tips

  • Set spreader opening 3/4 open
  • 8 lbs or 1/5 bag of Milorganite covers 500 square feet
  • Walk at an even pace

To get the best results from Milorganite, you must be able to apply the right amount to your lawn.  This can only be done if your lawn spreader is accurately calibrated.  As spreaders become older and worn, re-calibration ensures you obtain the best results from your investment in Milorganite. 

To calibrate your spreader, follow these steps. It only takes a few minutes.

  1. Set your spreader so that the opening(s) in the bottom are ¾ open when engaged.
  2. Put eight pounds or 1/5 of a bag of Milorganite into your spreader.
  3. Begin fertilizing your lawn, starting along an edge, and continue until the spreader is empty.  Leave the spreader where it was when it ran out of Milorganite.
  4. Measure the area of lawn you fertilized.  You should have covered about 500 square feet (20’ x 25’, 10’ x 50’, etc.).  If so, skip steps 5 and 6 and continue fertilizing your lawn.  If not, go to step 5 or 6.
  5. If you covered much more than 500 square feet, increase the size of the opening(s) in the bottom of the spreader and repeat steps 2-4 on an unfertilized lawn area.
  6. If you covered much less than 500 square feet, decrease the size of the opening(s) in the bottom of the spreader and repeat steps 2-4 on an unfertilized lawn area. 

Spreader tips:

• Clean your spreader after each use. 
• Follow manufacturers’ instructions as to lubrication, cleaning and storage.
• With drop spreaders, overlap the wheel tracks.  This helps ensure you don’t leave 2-3 inch non-covered strips between each pass. With rotary spreaders, overlap the coverage. 
• For most spreaders, more fertilizer is applied nearer to the spreader than at the farthest reach of the pattern.  Your spreader manual should give you tips on how far various types of fertilizer are thrown.

•Walk at an even pace.  When you slow down or speed up, the amount of Milorganite applied will change.  Slower speeds will increase rates and faster speeds will decrease rates.